Special Hole Calculator

Estimate RPM, feed, peck strategy, and cycle time for trepanning, reaming, and micro-drilling.

All tools free forever

Tip: Choose process method first, then tune diameter, depth, and feed.

Results

1,085.1
Spindle speed (RPM)
86.81
Feed rate (mm/min)
326.7
Removed area estimate (mm2)
2
Recommended pecks (n)
0.922
Estimated time (min)
Linked Parameter Diagram
specialHole

Input / Output Bars

Inputs

Hole diameter30
Tool diameter22
Hole depth40
Cutting speed75

Outputs

Spindle speed1,085.147
Feed rate86.812
Removed area estimate326.726
Recommended pecks2

Geometry View

Machining Window

specialHole
Spindle speed
1,085.147
Feed rate
86.812
Removed area estimate
326.726
Recommended pecks
2
Hole diameter
30
Tool diameter
22

Tool role and boundaries

Special Hole Calculator is not a one-shot number widget. It is an engineering baseline tool for real shop-floor decisions. Estimate RPM, feed, peck strategy, and cycle time for trepanning, reaming, and micro-drilling. This tool focuses on thread and hole features where tolerance stack-up and cycle strategy dominate first-pass yield.

Treat every output as a first-pass candidate, not an immediate production command: run defaults first, tune one variable at a time, and record machine, tooling, fixture, and material-lot context.

Fast baseline workflow

  1. Run once with defaults to confirm units and expected behavior.
  2. Lock constraints first (dimensions, machine limits, setup boundaries), then tune controls.
  3. Change one key variable per iteration and record why it changed.
  4. Check primary outputs against machine capability before secondary metrics.
  5. Validate first piece with conservative override before moving to target cycle.
  6. Store accepted values with revision tags so shift handoff stays reproducible.

Input strategy

Use a three-layer input model:

  • Constraint layer: dimensions, tolerances, travels, clamping, controller limits.
  • Control layer: speed, feed, engagement, compensation, cycle parameters.
  • Target layer: takt time, cost, scrap risk, tool-change frequency.

A common failure mode is pushing control values before constraints are stable. Lock constraints first, then build a stable operating window with small increments.

Output interpretation

Interpret results in order: primary safety checks first, then stability, then economics.

  1. Safety: no machine, tool, or fixture limit violations.
  2. Stability: load, thermal, and vibration behavior remains controlled.
  3. Economics: cycle and cost align with shift target.

Current focus outputs include RPM, Feed rate, Peck recommendation. If numbers conflict with floor behavior, verify units and inputs before changing strategy.

Typical failure modes and fixes

  • Sudden output jump: verify units, decimal precision, and input ordering first.
  • Unexpected trend: inspect workholding, tool condition, and thermal stability before retuning.
  • Big machine-to-machine delta: compare servo behavior, coolant coverage, spindle health, and compensation tables.
  • Shift handoff instability: enforce revision logging for program, tool, and parameter timestamp.

Keep rollback points and use single-variable increments to avoid coupled uncertainty.

FAQ

Can outputs be used directly for production?

Not immediately. Validate first piece, then short-run stability, then release to full production.

Why does floor behavior differ from computed values?

This is expected. Material lot, tool wear, thermal state, and machine dynamics all shift outcomes.

When should I recalculate?

Recalculate whenever tooling, fixturing, material lot, controller parameters, or takt target changes.

Final recommendation

Use Special Hole Calculator inside a fixed loop: baseline, first-piece validation, single-variable tuning, parameter freeze, and revision tracking. The outcome is not just one result but a repeatable process capability.