Category Machining Parameters

Feed per Tooth

Advance distance per tooth per revolution.

Feed per Tooth

Definition

Advance distance per tooth per revolution. Use this entry as a shop-floor reference, not as a detached textbook definition.

Formula / Rule

  • fz = vf / (z × n)

Typical Range & Scenarios

  • Recalculate after flute count or engagement changes.
  • Review the result against setup, rigidity, and inspection method.

Common Errors / Troubleshooting

  • If chips smear, chip load may be too low.
  • Recheck state, datum, and measurement chain before editing offsets or code.

Source-grounded Evidence

  • 来源定义每刃进给量 FZ 为每个刀刃每转的进给距离，并支持通过 FZ 软键结合刀刃数计算路径进给率。
  • 来源明确提及在 G95 FZ 模式下使用每齿进给量概念来给定旋转进给。

Related Terms

Feed Rate Spindle Speed Cutting Speed Chip Thickness

More in This Category

Acceleration Axial Engagement Chip Thickness Chip Width Constant RPM Constant Surface Speed (CSS) Cutting Force Cutting Power Cutting Ratio Cutting Speed Cutting Temperature Depth of Cut (ap)

Related Tools

Explore more tools relevant to this workflow.

Feed & Speed Calculator

Calculate spindle speed, feed rate, and material removal rate for milling.

Grooving Calculator

Estimate grooving feed distance, cycle time, and removed volume.

Center Drill Calculator

Estimate center drilling depth and feed time.

Baseline Parameter Lookup

Look up baseline feed, speed, and depth values from a 4×4 material/operation table.

Was this helpful?